Installation Method Of Aluminum Honeycomb Panel

Aluminum Honeycomb Panel is suitable for civil construction, vehicle, and boat decoration, etc. It is the application of aviation and aerospace materials in the field of civil construction. The entire processing process is completed in a modern factory, using hot pressing technology. Due to the high thermal conductivity between the aluminum skin and the honeycomb, the thermal expansion and contraction of the inner and outer aluminum skins are synchronized; the honeycomb aluminum skin has small holes so that the gas in the plate can freely Flow; the slidable mounting buckle system expands and contracts without causing structural deformation. under. Let's take a look at how to install it:

1. The lifting ear and the honeycomb panel are separated. The lifting gear is connected to the glue seam position of the honeycomb panel after being processed separately. The suitable width of the glue seam is ≥12mm. This installation method makes the processing simple and the installation convenient.

2. When processing the aluminum honeycomb panel, the flange for installation is processed. The installation only needs to be connected to the keel and the glue seam. The suitable glue seam width is ≥ 10mm. This method is easy to install, but the processing is slightly complicated, which is not applicable. in modeling curtain wall panels.

3. Aluminum buckle type, the buckle is a specific profile, and the installation is simple, but this method has high requirements on the processing accuracy of the plate, and is not recommended for plates with a length greater than 3000mm. According to the width of the buckle strip, there are 20mm and 40mm in the middle seam of the plate.